Belt conveyors material handling scattered

Caesar conveyor belt material is a common problem, the reasons are multi-faceted. But the focus is to strengthen the daily care and maintenance.

1 reprint reprint scattering material at the point of the point spread mainly in the fall feed hopper, guide trough, etc.. If severe overload belt conveyors, belt conveyors

guide trough backgauge rubber apron damaged steel guide trough at design time far away from the belt rubber apron so that the material out of the relatively long lead materials

Slot. The situation can be transported in the control capacity, enhance maintenance be resolved.Extendable conveyor

(2) when the concave section of the belt material spreading vacant belt concave segment interval when the radius of curvature smaller concave segment will generate vacant belt,

then the belt into a trough situation changes, because the belt has left the trough idlers, generally groove angle becomes small, so that part of the material spread out.

Therefore, in the design

Design stage should be possible to use a larger radius of curvature of the concave section to avoid this from happening. If the mobile mechanical ship loader, stacker-reclaimer

device in order to shorten the trailer and the concave section designed here no arc transition interval, when the belt width smaller redundancy selection easier

Scattering material.gravity skatewheel conveyor

3 when the scattering material deviation belt deviation scattering material is because when the belt is running two edge height changes, while high, while the other side is low,

the low side of the material from spreading out, processing method is to adjust belt deviation.