Its pitch pipe belt conveyor idler design points

    When the pipe belt conveyor lines running with no vertical or horizontal bent, upper stroke (or pipe belt conveyor carrying side) at the bottom of three roller conveyor and

materials to withstand the weight of the top three roller conveyor into a tube shape to maintain. When a vertical conveyor and

Horizontal bent portion, the other around the conveyor idler roller bearing may be, and the rest to maintain the conveyor roller tube shape. Next trip (ie, the return pipe belt

conveyor) is the same. Next trip or return conveyor to maintain tube shape manipulation, rather than the generic beltscrew conveyor

That the use of flat-shaped conveyor belt, in order to ensure the same structure and size of load side guide belts curved section through a vertical or horizontal.
    Around the roller conveyor is often called circular tube to keep the roller (PSK roller). Idlers diameter and spacing of the size of the pipe belt conveyor and the

transportation of materials decision. Because after a pipe stiffness, the conveyor belt sag meet the requirements of the case, compared with the general conveyor

, Roller spacing is relatively large. Polygon composed of idlers idler roller panel can be installed on both sides of the belt clip in order to avoid running into the gap

between the rollers causing the accident.Pipe conveyor
The end of the conveyor transition (from the flat-belt conveyor belt rolled into tube-shaped), with similar general conveyor, conveyor belt by a different groove angle of roller

group support. Here, through the guide chute of the conveyor load, to ensure that the material added near the longitudinal centerline of the belt, which will help lose

Conveyor belt running, charging plates located under the center of the roller conveyor can absorb shock loads loaded materials. At the beginning of the tube-shaped with a

special set of rollers, arranged by the 12 do not overlap two hexagonal rollers components. 12-gon idlers surrounded the tube-shaped than

Using a standard hexagon idlers closer round, able to withstand very high loads seal pressure. In addition to these idlers, but also uses a special set of guide rollers, the

conveyor belt roll together in front to hold the side to below the other side. The rollers on the installation of the first

Polygon front roller group to eliminate belt edge wear, and closed lap belt correctly.
    Idler alignment and proper loading of the pipe belt conveyor stability and plays a key role in guiding. In a general-purpose conveyor structure, roller frame alignment in

the horizontal and vertical plane, for the correct orientation conveyor belt, complete run is very important, and the use of self-aligning roller

To adjust the incorrect orientation or conveyor deviation. Because pipe conveyor belt is driven around each side of the guide roller, conveyor functions and overcome by bending

at the center conveyor deviation problems. In the pipe belt conveyor is running, you can still adjust the conveyor idlers ride

Take part in the load side as far as possible in the top. However, in fact, mainly to stabilize and maintain their lap belt portion at or near the upper position the weight of

the material being conveyed. 75% of tube cross-sectional area of ​​the center of gravity of the belt material to maintain proper dynamic performance. In

A return or no-load side of the lap belt portion is located below the tube-shaped, so that the weight of the lap on the return to maintain proper dynamic performance.