Conveyer belt conveyor run is one of the most common faults

Conveyer belt conveyor run is one of the most common faults. Deviation of a variety of reasons, the main reason is to install low precision and day-to-day maintenance.
The installation process, as far as possible between the head and tail rollers, the intermediate roller in the same center line, and parallel to each other, in order to ensure

that the conveyor belt is not biased or less biased. In addition, the tape tab to the right, should be the same on both sides of the perimeter.
In the course, if there is deviation, they have to make the following checks to determine the cause, make adjustments. Conveyer always check the location and processing methods:
1, check the idler misalignment of the lateral longitudinal centerline of the center line of the belt conveyor. If you do not coincide value is greater than 3mm, you should take

advantage of idlers on both sides of the elongated mounting holes to adjust. The specific method is to tend to which side of the conveyor belt, the idlers of which the lateral

conveyor belt forward direction forward, or backward in the other side.portable conveyor
2, check the head, the tail rack mount bearing two plane deviation. If the deviation of the two planes is greater than 1mm, then the response to the two planes is adjusted in

the same plane. The head roller adjustment method: conveyor belt deviation to the right side of the drum, the right side of the roller bearing seat should move forward or

backward in the bearing seat on the left; conveyor belt deviation to the left side of the drum, the left side of the roller bearing seat should be moved forward or backward in

the right side of the bearing housing. Rear roller adjustment method and the head drum is just the opposite.Plastic belt conveyor
3, check the position of the material on the conveyor belt. The material in the conveyor belt is not centered on the cross-section, will result in the belt running. If the

material is biased to the right, the belt deviation to the left, and vice versa. Should be used as much as possible so that intermediate material. In order to reduce or avoid

deviation increase the stopper plate to change the direction and position of the material in such a conveyor belt.