On the conveyor belt deviation should check the location and how to deal with

At runtime conveyors, belt deviation is a common fault, one of many reasons for this failure, the main reason is to install low precision and routine maintenance are not in

place.
Conveyor during installation, try to ensure that the head and tail roller, intermediate roller in the same center line, and the two should be parallel to each other to ensure

that network with no partiality or less biased. In addition, the strap connector to connect properly, should be equal on both sides of the perimeter, which is also effective

measures.
Well, the conveyor belt deviation, to check the location and processing methods, what does?Food conveyor
Xiao Bian consulted professionals Evergreen transportation machinery, according to them, to check the location and processing methods are:
(1) Check the roller conveyor transverse centerline longitudinal centerline and degree of coincidence
If there is no overlap, and the deviation exceeds 3mm, should be adjusted, you can use idlers elongated mounting holes on both sides to adjust the specific approach is: to see

which side of the conveyor belt is biased, which side idlers the conveyor belt to move forward or backward one side

.
(2) Check the head, tail rack bearing two plane deviation
If the deviation is greater than two planes 1mm, the two planes should be adjusted to align to the same plane.Screw conveyor
As for the head drum, the adjustment method: If the conveyor drum right to offset, then the right roller bearing should be moved forward or backward movement bearing left; if

the left side of the drum conveyor shift left of the mobile roller bearing, direction of movement

Ibid; while the tail roller adjustment methods are contrary to the head drum.
(3) Check the position of the material on the conveyor belt
If the material on the conveyor cross section, and is not centered, it will cause the belt deviation. If the material is skewed to the right, then the belt is deviation to the

left, and vice versa. Therefore, when used, should try to make the material center, you can also increase the blocking plate, because blocking plate

Can change the direction and position of the material, thus avoiding belt deviation phenomenon occurs.