Feeder controller adjustment method

1 Turn on the machine and the fans, and compressors, pulse valve for 10-20 minutes.
2 hosts on the controller current adjustment knob clockwise to tune in the end. Amplitude adjustment knob to the middle position.
3 Start the host, the controller hit the automatic position and turn the power switch, turn off the fan air valve slowly and observe the fan when the current reaches 60A fixed,

left or right cyclone current adjustment knob and observe feeder ammeter , ammeter pointer can swing around.Conveyor System
4 fan damper fully open, and quickly increase the feeding amount "of the amplitude adjustment knob clockwise in the end you can" while observing the current host, when the host

immediately when the current reaches 130A counterclockwise rotating hosts the current adjustment knob, Feeders can swing around the ammeter pointer

. Locking current adjustment knob.
5 power for about 5 minutes observing whether the fan current 60A-65A "clockwise decreases the fan current" current adjustment knob trim blower, fan current stability was

observed in the 60A-65A 5-10 minutes, meet the requirements of current locking fan current regulation knob.
6, if the machine is running a slight blanking, trimming amplitude knob "counterclockwise."
7 Note: The current general situation after a good tune and fans do not need to adjust the current host, you can control the feeding amount.Mine conveyors