Conveyor bearing vibration how do

First, we have the hysteresis characteristics of the ordinary ball milling production.Ordinary characteristics, in order to better control the output, you must grind cycle

changes, the Pallet conveyor, such as the production of the desired particle size material flow.Besides humidity and abrasion resistance, etc.

Easy to change the material properties, and grinding mill liners and changes in the mill load (i.e. mill filling volume) control becomes more complex, the above factors

difficult.Changes under certain conditions, either the open or closed water grinding mill has best.If you can

To keep the mill load or fill a value or a range of volume, quantity of contents, the mill will enable the highest yield per unit of time, unit power consumption can be reduced

to a minimum, kept in top condition is the best, long-term stability run of the mill, grinding and sufficient to prevent air, indirect materials

Material, in order to prevent over-grinding phenomenon.
Mill equipment solution is an advanced production management system, the system sensing devices and two computing device processing parts.Captured milling parameter measurements

using sound, basic form is to capture the best material / balls per grinding than sound is usually the most Jia constant value.The best

Value does not change with the ball or the ball wear change.Advanced anti-crosstalk feature allows more than one mill will not work to achieve the best results when there are

too many errors.

A conventional analog multi-collection will greatly increase the cost of production because the original single analog wealth mechanical engineer to adjust the panel in the

development of high cost dual analog tuning panel, use audio and audio sensing and ground dual-sensor data to determine mill, the computer

And software investment in working condition, just need to do some programming and adjust the corresponding sensor, the command is added to the instruction set of dual analog

switch control, you can select the user to complete the production of the appropriate combination.

In addition, the current switch factory, generally use only a test parameter, which is the sound of grinding a warehouse; in the closed circuit mill, if a well-off hoist

grinding capacity, they can only be used as a control parameter in the Conveyor System w ability positions.Lo friction sound only restricts mill output

Increased friction sound with only one position and the necessary data such as sensor hoist two optional parameters control parameters.Other power back to the flow of powder,

mill inlet, outlet pressure, the main motor power, bearing vibration, vibration mill body in a certain conditions, can also reflect

The conditions inside the mill, but the lag time is too long or no fixed optimum value, you can not use automatic control.To end, wealth machine settings selected by the user

configuration of this section, if the user needs, you can install debugging; if the user wants cost, the device can be omitted