Belt-site treatment

The treatment site is as follows:
1, automatic roller detuning
When the conveyor belt deviation range of small, you can place the belt deviation, installation aligning roller.
Spherical roller group has a variety of types, such as intermediate shaft type, four-link, vertical roller type, and so, the principle is the use of block or roller rotates in

the direction in the horizontal plane blocked or automatically generate horizontal thrust to the heart of the tape to adjust the tape deviation purposes. Generally shorter in

overall length, or belt conveyor belt conveyor bidirectional runtime using this method is more reasonable, because the shorter, easier deviation conveyor and not easy to adjust.   Heat Exchanger

And long better not take this approach, because the self-aligning roller group would use the service life of the tape have some impact.
For fixed belt conveyor, when the belt running, you can not move the idler position with ways to correct the deviation phenomenon, so in every segment overloaded conveyor idlers

10 groups set up a group of Rotary aligning roller trough, back to an empty segment every 6-8 group settings a set of parallel aligning roller.
2, unilateral edger detuning
Always deviation to the side conveyor, conveyor side of the deviation in the range of plus certain vertical roll, so that belt is reset. When the belt running across the side of

the vertical roller, vertical roller driven turret rotation, so that conveyor belt moves to the center, then the trough idlers and rollers also come swinging parallel, so that

the belt deviation is corrected come.  Metal detector for food
3, moderate tension detuning
When the conveyor belt Huzuohuyou, orientation to time, indicating belt is too loose, the tensioning device can be adjusted to eliminate the deviation.
4, adjusting drum detuning
Conveyor belt at the deviation of the drum, the drum is abnormal or traverse checking, adjusting the normal rotation of the drum to the horizontal position, eliminating the

deviation.
Reversing drum drive pulley and belt deviation adjustment adjustment is an important part. Because at least a belt conveyor rollers 2 to 5, all the rollers must be perpendicular

to the installation location of the longitudinal direction of the conveyor centerline, if the skew is too large deviation inevitable. Adjustment Method and its group of similar

idlers. For the head drum as the drum belt deviation to the right, the right of the bearing should be moved forward, the left side of the tape deviation of the drum, the left

bearing housing should be moved forward, also the corresponding After moving the left or right side bearing housings after the shift. Rear roller adjustment method and the head

drum opposite. After repeated adjusted until the tape transferred to an ideal location. After adjusting drum driven or commutation best pre-install its exact location.
5, the correction of offset conveyor belt joint
Always a belt running direction, and the maximum deviation in the joints, fittings and conveyor belt can be corrected to eliminate the vertical midline deviation. Ie apart redo

connector.
6, padded roller detuning
Belt running direction, distance must be in the opposite direction deviation padded roller several groups, eliminate deviation.
7, adjusting idler detuning
Belt running direction must, examination revealed roller conveyor line and the center line is not perpendicular to the roller can be adjusted to eliminate the deviation.
8, to eliminate slime detuning
Conveyor deviation point unchanged found roller, roller adhesive slime, it is necessary to eliminate slime detuning.
9, the correction of offset feed
No deviation belt light load, heavy deviation, adjust the feed weight and location, eliminating the deviation.
10, the correction of offset bracket
Belt running direction and position fixing, severe deviation, adjust the horizontal and vertical brackets, remove deviation.