Roller conveyor operation and maintenance

Belt conveyors capacity, long distance transport , smooth transportation , materials and conveyor no relative motion , while less noise , simple structure , easy maintenance,

less energy consumption , Flat belt conveyor should be fixed in the course of their work staff to look after. Attendants must be a general

Technical knowledge and the performance of the conveyor familiar with those . The use of units of the conveyor should develop " equipment maintenance, overhaul, safety

procedures " in order to comply with minders . Attendants must have a shift system . The Elevator conveyor feeding should be uniform, not leaving too much feed

The material feed hopper was filled with the overflow. Conveyor working process , the non- minders should not be near the machine ; any person not touch any rotating parts.

Failure occurs , you must immediately stop operation , eliminate the fault . If the work is not easy to immediately remove it without too much impact on the lack of

Depression, should be recorded , pending overhaul eliminated. Custody of the conveyor should always observe the operation of the various components , check the connecting bolts

everywhere , found loose in a timely manner tighten. But the absolute prohibition of conveyor operation, moving parts on the conveyor for cleaning and repair . Tail assembly

screw

Should be adjusted to fit screw tensioning device to maintain belt tension with normal work . Attendants should always observe the work of the conveyor belt , where local damage

, depending on the extent of damage should decide whether to replace or be immediately replaced with a new overhaul . Remove the belt should be considered on its

Wear and for other purposes . Custody belt conveyor is to observe their work status when , cleaning , lubricating and adjusting screw tensioning device such checks sporadic work

. Belt conveyors should normally start at no load , the material emptied after parking . In addition to the course of the conveyor

Maintain normal lubrication damaged parts and replace them individually , each working six months must be overhauled once. Overhaul must be eliminated in use and documented

defects removable parts and scrap loss replacement lubricants. Conveyor units can be used according to the working conditions of development of maintenance weeks

Period .