Conveyor belt deviation should check the location and how to deal with

We know the device when in use will have a lot of questions, then Shang Hao conveyor manufacturers will tell you about when running Flexible Roller Conveyor belt if the deviation , then how to

do , in fact, cause such a failure for many reasons, including the most important is the daily maintenance and

Maintenance is not the best place . Well , the conveyor belt deviation , to check the location and processing methods , what does ?
( 1 ) Check the roller Gravity roller conveyor transverse centerline longitudinal centerline and degree of coincidence
If there is no coincidence , then , plus the deviation exceeds 3mm , then it needs to be adjusted , but also according idlers elongated mounting holes on both sides to adjust ,

so that some of the specific method is to look at the mesh belt conveyor idlers which side bias which group lateral conveyor belt moves toward the forward direction

Move, there is another side after the shift.
( 2 ) Check the head, tail rack bearing two plane deviation
If the deviation is greater than two planes 1mm, the two planes should be adjusted to align to the same plane. As for the head drum , the adjustment method is: if the right side

of the drum belt shift , then the right roller bearing should be moved forward or backward on the left bearing

; If the left side of the drum belt shift left of the mobile roller bearing, direction of movement above; while the tail roller adjustment methods are opposite to the head drum

.
( 3) Check the position of the material on the conveyor belt
If the material on the conveyor cross section , and is not centered , it will cause the belt deviation. If the material is skewed to the right , then the belt is deviation to

the left , and vice versa. Therefore, when used, should try to make the material center , you can also increase the blocking plate , because blocking plate

Can change the direction and position of the material , thus avoiding belt deviation phenomenon occurs .