Belt plastic cover damage processing

( one ) partial degumming , forming nest pit . Mostly underground coal containing liver stones and more, resulting in a large block .
Chute mounted too high , the impact screw conveyor force . Feeding device should be corrected to increase the buffer device , lower feed height , or chute slope decreases.
The damage mentioned above , can be vulcanized patch , underground cold viscosity is required. The same way as above .
( Two ) vertical cracks. More in the guide plate at the bottom . The reason is bad installation or material guide board . Should be re- installed, do not make contact with wood

or iron belt ; roller or damage ; damage or tail flap ; belt buckle damaged or hanging bad ; lug or damaged, worn on the layer ;

Sweeper flat iron or a bad angle to hang the belt . Approach should replace the damaged section of the belt , carefully check whether the length of the damaged parts , spiral conveyor bad parts

grid update .
( Three ) lower wear and concentrated . Multi- segment belt there is no load materials , objects or cleaning does not work ; damaged, do not rotate ; too much or roller adhesive

materials , such as coal mine , stone fall to the dead zone F- belt, roller, installed , including board sweeper . Or plant extinction roller should be regularly

Sweep .
( Four ) transverse cracks on the tapes . The reason is not enough or rubber belt tension due to aging . Repair methods in addition to switch to multi- layers of tape , but can

reduce the maximum tension .