Teflon conveyor belt deviation solution

Use Teflon conveyor belt conveyor belt Teflon runtime deviation is one of the most common faults, deviation a variety of reasons, mainly due to the installation of low precision

and routine maintenance is poor, the following summarizes some of the common causes and solutions for all kinds of use of iron

Teflon conveyor belt maintenance officers.
Teflon conveyor belt with the installation process, the head and tail rollers, between the intermediate roller on the same center line as, and parallel to each other in order to

ensure unbiased conveyor or less biased. In addition, the tape tab to the right, should be the same on both sides of the perimeter.Plastic belt conveyor
Teflon conveyor slipping phenomenon, causes and solutions:
Teflon conveyor Symptom: Teflon conveyor belt slippage.
Teflon conveyor Cause: Teflon conveyor normal operation, the belt speed should not be less than 95% of the roller speed. If the friction roller conveyor with enough Teflon,

Teflon conveyor belt prone to slipping phenomenon. Causing friction roller conveyor with Teflon non-

Enough for many reasons, common are: load start, roller surface friction coefficient is not enough, not enough tension so on. Roller surface coefficient of friction is not

enough reasons; roller coated plastic wear too much with too wet or sticky body lubricant with a sticky surface material (easily soluble rise);

Tension enough reasons: tensioning stroke is not enough, not enough counterweight weight, Teflon conveyor belt is too long and so on.material handling conveyor
Teflon conveyor failure Solution: Clean up roller surface, dry Teflon conveyor belt body, clean Teflon conveyor belt body, adjusting tensioning stroke, increased weight weight,

shorten the length of Teflon conveyor belt.
Teflon conveyor deviation phenomenon, causes and solutions:
Teflon conveyor Symptom: Teflon conveyor belt deviation.
Teflon conveyor deviation check the location and processing methods:
(1) Check the lateral centerline of the roller conveyor with Teflon belt longitudinal centerline misalignment. If the misalignment exceeds 3mm, you should use idlers elongated

mounting holes on both sides to be adjusted. The specific method is biased Teflon conveyor belt which side roller group which

Teflon conveyor belt to the side of the forward direction forward, backward or the other side.
(2) Check the head, tail rack bearing two plane deviation. If the deviation is greater than two planes 1mm, the response to adjustment of the two planes in the same plane. Head

drum adjustment method: If the Teflon roller conveyor to the right deviation, the roller bearing right should

When moving forward or backward bearing left; Teflon conveyor belt to the drum if left deviation, the roller bearing should be left or right to move forward bearing after the

shift. Rear roller adjustment method and the head drum opposite.
(3) Check the Teflon material in position on the conveyor. Teflon conveyor belt material in the cross section is not centered, will lead to belt deviation. If the material is

biased to the right, then the Teflon conveyor belt deviation to the left, and vice versa. Should be used as much as possible so that the material centered. To reduce the

Little or avoid such deviation increase Teflon stopper plate conveyor, to change the orientation and position of the material.