Inclined belt conveyor belt repair and maintenance method resolution

  Inclined belt conveyor with a large open-pit resulting from the application, power plants, cement factories and ports, etc., but also has a large transmission capacity, low

energy consumption, easy maintenance, etc., will become dominant in the conveyor. However, at work due to improper use or belt unexpected, will lead skirt

Plastic bucket edges and tear or fall off, replace the belt will increase production costs. To reduce production costs, research and explore large angle belt conveyor belt

repair process points necessary.
  Inclined Turn conveyor belt repair and maintenance method resolution
  Inclined belt conveyor installed idling two hours after the first check the belt for cracks or fall off, if it should be timely treatment; early feeding of design capacity

load of about 50%, after a period of time to determine the correct operation of the normal load and then feeding operation; the course of the

Found that large angle belt conveyor and out side there aggregates, should be promptly stop treatment, to prevent skirts or plastic bucket off.
Inclined 90 degree turn conveyor belt cracking or peeling, repair should note the following:
    1, clean up the site sanitation, and to be bonded skirts, plastic bucket bonding surface and the belt surface clean.
    2, with a polishing machine will be uniform and thin belts, skirts and other bond hair and clean place to play, but the belt canvas layer or can not appear at the uneven

fight hair.
    3, gluing before the first binder with a hardening agent uniformly mixed by a certain percentage, so that the adhesive has cured with a quick, strong bond, heat resistance,

heat aging and bonding does not require a fixed pressure and so on.
    4, gluing coating is to be strong, thin and uniform coating, if the belt canvas fabric layer or other layers or particles to fight hair loss at the obvious, to brush more

than three.
    5, to be dried to a non-stick coating back when skirts or plastic bucket gradually pressed home with the coating, but with a hammer beating from the middle to the edge

ordered to rule out internal air.