Belt Conveyor Idler deviation debugging method

Resistance to eliminate less severe: If conveyer, conveyor belt should run laterality roller cleaned, and a few drops of machine oil on the roller bearings to reduce the idlers

The frictional resistance, the angular velocity of rotation of the roller to speed up, you can eliminate the deviation.

Material flow correction method: If the belt-load deviation, heavy-duty operation deviation, the uneven distribution of the material on the conveyor belt, feed valve is not correct, it should be corrected feed downpipe

Or the installation guide plate to change the blanking position, to adjust the material flow directions, so that uniform distribution of material on both sides of the conveyor belt.pallet conveyor

Joint correction method: If the conveyor belt is running and always to the side deviation, maximum deviation just in the joints, and the deviation of the position is uncertain. Conveyor belt joint is not correct, it should be recalibrated

Connector or glued joints.

Stent correction method: the conveyor belt running to the same side of the deviation, and more serious in the same location, said the Minto roller stand or rack distorted errors should be corrected stand or rack water

Roughness and vertical, replace the are serious distortions bracket or rack.

Conveyor belt repair method: If the edge of the conveyor belt is badly worn, so inconsistent on both sides of the conveyor belt tension, the belt running position is not fixed, according to the actual situation should be promptly repaired or

Profile.Metal detector for food

Idlers of offset method: such as the total conveyor-load to the side deviation in conveyor belt run laterality center position a roller frame rack join the four mounting bolts Remove the three

, Leaving a when the shaft when one side of the conveyor belt to the stand deviation forward movement of the bracket along the conveyor belt running direction of the appropriate angle and then fixed. Conversely, when the conveying

With toward the other side of the deviation, you can send the bracket to move in the direction of the conveyor belt running the appropriate angle and then fixed conveyor belt deviation phenomenon will disappear

Tensioning device method: If the conveyor belt to load or reload run to the same side of the deviation, the degree of tightness on both sides of the conveyor belt is inconsistent, according to the law of "running tight do not run loose"

Drum at the front and rear adjustment screw or counterweight tensioning device, the conveyor belt will be reset to normal operation.