Check the location of the material on the conveyor belt

A conveyor belt of deviation and its treatment

Deviation conveyor belt conveyor running is one of the most common faults . There are many reasons for deviation , the main reason is to install low precision and routine

maintenance is poor.

During installation , between the head rubber belt conveyor and tail rollers , the intermediate roller on the same center line as possible , parallel to each other and to ensure that the belt is not

biased or less biased. In addition, the strap connector to the right, should be the same on both sides of the perimeter .

During use , if there is deviation , they have to make the following checks to determine the cause , be adjusted. Incline Belt conveyor Conveyor deviation always check the location and processing

methods are:

1, check the rollers do not coincide with the center line of the transverse conveyor longitudinal centerline . If the values ​​do not coincide more than 3mm, you should take

advantage of the elongated mounting holes on both sides of idlers be adjusted . The specific method is biased on which side of the conveyor belt , which the lateral conveyor

idlers forward

Forward direction or another after the side shift.

2, check the head , tail rack-mounted bearing deviation of two planes values. If the deviation is greater than two planes 1mm, the adjusted response to the two planes in the

same plane. Adjustment of the head drum is : If the conveyor roller deviation to the right , then the right side of the roller bearing should move forward

After moving or left bearing shift ; If the conveyor roller deviation to the left , the left side of the roller bearing should move forward or to the right bearing after shift.

Rear roller adjustment method and the head drum opposite.

3, check the position of the material on the conveyor belt . Material is not centered on the conveyor cross-section , will lead to the conveyor belt deviation. If the material

is biased to the right, then the belt deviation to the left , and vice versa. In should be used as much as possible so that the material in the middle. To reduce or avoid such

conveyor run

Partial increase the blocking plate , change direction and position of the material.